Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
gecko-systems:gecko3tester:start [2017/03/06 12:20] – external edit 127.0.0.1 | gecko-systems:gecko3tester:start [2021/12/20 10:49] (current) – external edit 127.0.0.1 | ||
---|---|---|---|
Line 1: | Line 1: | ||
<box 300px right | **Project details**> | <box 300px right | **Project details**> | ||
^ Name: | GECKO3TESTER || | ^ Name: | GECKO3TESTER || | ||
- | ^ Maintainer| [[huce: | + | ^ Maintainer| [[gecko-systems: |
^ Revision: | unknown || | ^ Revision: | unknown || | ||
^ Development status: | unknown || | ^ Development status: | unknown || | ||
Line 20: | Line 20: | ||
We provide two different test configurations: | We provide two different test configurations: | ||
- | * {{:huce: | + | * {{::gecko-systems:gecko3_tester: |
* FIXME - coming later < | * FIXME - coming later < | ||
Runtime: 30 seconds. | Runtime: 30 seconds. | ||
Line 30: | Line 30: | ||
===== Test setup ===== | ===== Test setup ===== | ||
- | {{ :huce:microlab: | + | {{ :gecko-systems:gecko3_tester: |
==== Required material ==== | ==== Required material ==== | ||
* GECKO3 tester | * GECKO3 tester | ||
Line 217: | Line 217: | ||
**Note:**\\ | **Note:**\\ | ||
- | The GPIO pin numbering used by the test software is different than the normal system bus names. Refer to the [[:platforms: | + | The GPIO pin numbering used by the test software is different than the normal system bus names. Refer to the [[:gecko-systems: |
If a error on the system bus or on a memory chip is detected, most of the time you will get a bunch of errors after that. Always look for the first detected error and try to fix that. Afterwards do another test run. | If a error on the system bus or on a memory chip is detected, most of the time you will get a bunch of errors after that. Always look for the first detected error and try to fix that. Afterwards do another test run. |